HellermannTyton SpotClip-Box Manuel D'utilisation page 12

Product overview
6 Fold over the ends of the cable tie (Figure
the cable tie socket into the connection area of the hood
(Figure ).
G
7 Install the connection area.
f 12 V: insert the connection cable through the cable
feed-through into the connection area (Figure
f 230 V: feed the connection cable through the cable
feed-through of the connection area into the hood from below
(Figure ).
I
8 Using both of the clamping rails supplied, connect to the mains
(Figure ).
K
9 Fit the cable grommet and complete the assembly.
f 12 V/230 V: insert the cable grommet in the groove provided. Fix
the connecting cable using the cable tie and tighten it up. Please
note that at least 4-5 cm of the connection cable must hang
from the hood to connect directly to the lamp. Cut off the
protruding end of the cable tie directly at the head (Figures
and ).
K
10 Close off the connection area with the cover (Figure
11 Position the hood on the base plate and close up the product
with the bayonet catch (Figure
12 Connect the lamp according to the operating instructions.
13 Fix the spotlight according to the operating instructions.
; The SpotClip-Box spacer is installed.
8
F
).
M
Operating Instructions • SpotClip-Box • 12-2016
) and thread through
).
H
J
).
L