Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.1
Installation
WARNING
Possible lethal danger due to fire!
The use of unsuitable insulating material and damp-proof foils or
vapour barriers can cause a lethal fire.
f
Comply with the local regulation on fire prevention and the
installation instructions from the light manufacturer.
f
Comply with the applicable stipulations and standards for
insulating materials and damp-proof foils or vapour barriers.
f
Do not use flammable insulating materials.
f
Only use flame-resistant damp-proof foils or vapour barriers.
f
Do not use insulating materials made of natural substances
such as wood, hemp or straw.
1
Measure and drill through the ceiling plate (see operating
instructions of the recessed light).
2
Clean the area surrounding the ceiling cut-out.
3
To increase the air-tightness, apply a little silicone sealant to the
groove on the base plate provided.
4
Position the base plate centrally over the hole and insert the
frame of the recessed light without the lamp and other
accessories. Clip the springs of the frame onto the base plate of
the SpotClip-Box and secure the frame.
5
Cut the cable grommet to fit and insert the cable.
f 12 V: cut the cable grommet to size in order to insert the
connection cable of the transformer. Connect the transformer
(Figure
).
D
f 230 V: push the solid conductors through the cable grommet or
cut the cable grommet and insert the cable (Figure
Operating Instructions • SpotClip-Box • 12-2016
Product overview
).
E
7
Publicité
Table des Matières
