Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 fitting brackets
- 1 set square
- 1 Ø5 threaded fastener
- 2 BHc 5x15 screws
- 2 Ø5 plastic washers
- 1 BHc 6x15 screw
Photo 1
Assembly
- Remove both fitting screws of belt protection to insert the 2 provided brackets as indicated on
photo 1. Do not tighten completely.
- On the other side, remove the M6 nut that holds on the stop rubber of the swinging arm: replace
it by the threaded spacer. Fit the set square with the BHc 6x10 screw and place the threaded
fastener as shown on photo 2.
- Position the rear hugger by centring it in relation to the tyre (on the ABS model, unfasten the
cable to put the rear hugger). Fit the rear hugger thanks to the provided BHc screws and washers.
The scratch band must be placed between the rear hugger and the swinging arm on the exhaust
pipe side.
- Tighten with a torque wrench of 1,2 Kg/m² for ABS model. Stick the self-adhesive pad on the
rear hugger to hold the cable.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Our rear hugger and undertray are compatible.
FITTING INSTRUCTIONS
Origine tyre Bridgestone BT012 in 160/60 R 15.
- 1 Ø6 plastic washer
- 1 Ø6 L : 20 mm threaded spacer
- 1 BHc 6x10 screw
- 1 scratch band of 3 cm
- 1 plastic ring
- 1 cable holder self-adhesive pad
Photo 2
«
»
ATTENTION
« REAR HUGGER »
500 T-MAX 2008 → ∞
}
For ABS model
Publicité
