Basic Operation - Makita GB602 Manuel D'instructions

WORK REST
GB602/GB801/GB602W
See Fig. 7.
1
2
Mount the work rests to the work rest bracket using the
two hex bolts.
Before tightening the bolts, adjust the gap between the
Grinding wheel and work rest to a maximum of 1/16 in.
(1.6 mm).
Tighten securely.

BASIC OPERATION

WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing dust.
If operation is dusty, wear a dust mask.
To be efficient and work as designed, your tools should be
kept sharp. Dull tools can and will cause accidents.
Bench Grinders are ideal for sharpening tools such as
chisels, planer blades, scissors, etc., and for removing
rust or corrosion.
WARNING:
Never sharpen or grind anything made of aluminum.
Grinders remove material rapidly so pressure is the key to
efficient grinding.
The proper way to sharpen a tool and avoid overheating
is:
■ Keep a tool on the work rest firmly at the correct the
wheel.
■ Keep the object in constant motion, moving it at an
even pace.
■ Never force a tool against the grinding wheel.
■ Keep the tool cool by using either a cooling tray, or a
pan of water.
■ The grinding wheel should rotate "into" the object being
sharpened.
NOTE:
Excessive pressure may damage the tool, cause the
motor to overheat, and prematurely wear down the
grinding wheel.
WARNING:
Excessive pressure on a cold wheel can cause the wheel
to crack.
8
1. Work rest
bracket
2. Hex bolt
Fig. 7
OPERATION
GB602W only
1
2
Mount the blade work rest to the work rest bracket using
the two hex bolts.
Before tightening the bolts, adjust the gap between the
Grinding wheel and work rest to a maximum of 1/16 in.
(1.6 mm).
Tighten securely.
GB602W only
How to attach saw blade-sharpening kit
1
2
■ Assembly and attach saw blade sharpening kit as in
Fig. 9.
Before using, make sure it is securely fastened.
1
5 6
4
Place the saw blade between holder A and holder B.
Then secure the assembly on the screw with the wing nut
A.
1
1. Work rest
2. Hex bolt
Fig. 8
1. Saw blade
sharpening kit
2. Bolt
Fig. 9
1. Grinding wheel
2. Screw
2
3. Wing nut A
3
4. Tool rest holder
5. Wing nut B
6. Stopper
7. Holder B
7
8
8. Tool rest
Fig. 10
1. Hex bolt
Fig. 11