Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating your French Door
Refrigerator
USING THE CONTROL PANEL
(1)
(2)
(3)
(8)
(7)
( 1 )
Freezer / Power Freeze (3sec)
The Freezer button serves two purposes:
- To set the Freezer to your desired
temperature.
- To turn the Power Freeze function on and off.
1. To set the Freezer temperature, touch the
Freezer button.
You can set the temperature between 5 °F
(-15 °C) and -8 °F (-23 °C).
2. Power Freeze function
Touch and hold this button for 3 seconds to
decrease the time needed to freeze products in
the Freezer.
It can be helpful if you need to quickly freeze
easily spoiled items or if the temperature in the
freezer has warmed dramatically.
(For example, if the door was left open.)
When you use this function, the energy
consumption of the refrigerator will increase.
Remember to turn it off when you don't
need it and return the freezer to your original
temperature setting.
If you need to freeze a large amount of food,
activate the Power Freeze function at least 24
hours before you put the food into the freezer.
DA68-02601D-00.indb 18
RF26J*
(4)
(5)
(6)
(10)
(9)
English - 18
( 2 )
Alarm / Filter Reset (3sec)
The Alarm button serves two purposes:
- To turn the door open alarm on and off
- To reset the water filter life indicator.
1. Door Alarm Function
If the door alarm is set to On, an alarm beeps if
any refrigerator door is left open for more than
three minutes.
The beeping stops when you close the door.
The door alarm function is pre-set to On in the
factory.
You can turn it off by pressing and then releasing
the Alarm button.
You can turn it back on in the same fashion.
The icon lights up when the function is on.
When the Door Alarm function is on and the
alarm sound is triggered, the Door Alarm Icon
will blink while the alarm sounds.
2. Water Filter Life Indicator Function
After you replace the water filter, touch and hold
this button for 3 seconds to reset the water filter
life indicator.
When you reset the water filter life indicator, the
Filter icon on the panel turns Off.
The Filter icon will turn red to let you know it is
time to change the water filter after six months
(about 300 gallons).
Some areas have large amounts of lime in their
water, which causes the water filter to clog more
quickly.
If this is the case in your area, you will have to
change the filter more frequently than every six
months.
( 3 )
Energy Saver
Touching this button turns Energy Saver mode
on and off.
When you turn Energy Saver on, the Energy
Saver icon lights.
Turn Energy Saver off and the icon goes off.
The Energy Saver function automatically turns on
when power is supplied to the refrigerator.
If condensation or water drops appear on the
doors, turn the Energy Saver mode off.
14. 11. 24.
11:08
Publicité
Table des Matières
