Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 1 bracket
- 2 BHc 5×15 screws
- 2 Ø5 plastic washers
Assembly
- Remove the original chain guard and keep both bolts that you will use to fit the hugger.
- Place the bracket on the right-hand-side of the swinging arm.
- Position the fender by taking care to align it well with the tyre.
- Fit the left-hand-side of the fender with the two original bolts of the original chain guard, and
right-hand-side on the bracket, thanks to both screws and both washers furnished, without
tightening excessively.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the
technical data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
* Our hugger and undertray are compatible.
« CAUTION »
FITTING INSTRUCTIONS
« REAR HUGGER »
GSF 1200 BANDIT 1996/2006
GSF 1250 BANDIT 2007 → ∞
GSX 1250 FA 2010 → ∞
original tyre 180.
Publicité
