Functions - Hortensus RG800 Mode D'emploi

5. The battery is not charging, or the mower does not charge properly, it
bumps the charge station again and again.
a) The extruding poles of the charger are not in contact with the paddles of the charging
station.
b) The extruding poles or the paddles are dirty. Clean them. (Make sure to disconnect the
power before cleaning.)
c) If long time no charge, the left power will be exhausted by itself. If the battery broken a
little you can re-charge many times to active the battery or you can change the battery.
d) The sensor of the machines is damaged.
6. The mower does not return to the charging station for charging.
a) The fence line is too long. The battery lever is not enough to return the mower to the
charging station. Turn off the mower and carry it to the station.
b) If the mower was stopped by obstacle it will stop working
7. Subarea function is failure.
Every working area need to set working time.
8. The island can not work.
The island should be circle，not square.
9. The mower makes a circle in the island and never go to the working
area.
The mower will go aroundabout3 circles, or about120seconds, depends on the size of the
circle. Then go into the working area.
Functions：
A) Select the mowing route intelligently;
B) Avoid collisions intelligently;
C) Take shelter from rain intelligently;
D) Return to charging station for charging intelligently;
E) Safe protection intelligently.