Installation Of Your Oven - Wolf Power WCR6060FS Notice D'utilisation

A
Electrical Connection and Security:
1. Your oven requires 6 or 32 Ampere fuse according to the appliance's power. If necessary, installation by a
qualified electrician is recommended.
2. Your oven is adjusted in compliance with 220-240 V AC, 50-60 Hz (or 230 V / 400 V AC, 50 - 60 Hz.) electric
supply. If the mains are different from this specified value, contact your authorized service.
3. Electrical connection of the oven should only be made by the sockets with earth system installed in compliance
with the regulations. If there is no proper socket with earth system in the place where the oven will be placed,
immediately contact a qualified electrician. Manufacturer shall never be responsible from the damages that will
arise because of the sockets connected to the appliance with no earth system. If the ends of the electrical
connection cable are open, according to the appliance type, make a proper switch installed in the mains by which
all ends can be disconnected in case of connecting / disconnecting from / to the mains.
4. If your electric supply cable gets defective, it should definitely be replaced by the authorized service or qualified
electricians in order to avoid from the dangers.
5. Electrical cable should not touch the hot parts of the appliance.
6. Please operate your oven in dry atmosphere.
Gas Connection and Security:
1. Fit the clamp to the hose. Push one of the hose until it goes to the end of the pipe.
2. For the sealing control; ensure that the buttons in the control panel are closed, but the gas cylinder is open. Apply
some soap bubbles to the connection. If there is gas leakage, there will be foaming in the soaped area.
3. The oven should be using a well ventilation place and should be install on flat ground.
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure that it is at the counter level. Bring it to the counter level by
adjusting the feet if necessary.
6. Do not make gas hose and electrical cable of your oven go through the heated areas, especially through the rear
side of the oven. Do not move gas connected oven. Since the forcing shall loosen the hose, gas leakage may
occur.

INSTALLATION OF YOUR OVEN

4