Service And Maintenance; Cleaning And Maintenance; Battery Charging - Mettler Toledo 64060625 Manuel D'installation

4

Service and Maintenance

This chapter covers
•

Cleaning and Maintenance

•

Battery Charging

•
Battery Maintenance
•
Troubleshooting and Service
•
Replacement Parts
4.1. Cleaning and Maintenance
When necessary, clean the 64060625 battery pack cover and battery charger with a clean, soft
cloth that has been dampened with a liquid that is safe for use in the hazardous area. Do not use
any type of industrial solvent such as toluene or isopropanol (IPA) that could damage the finish. Do
not spray cleaner directly onto the battery pack or charger.
Regular maintenance inspections by a qualified service technician are recommended. The
64060625 battery pack provides a rugged, stainless steel housing that is sealed to IP66
standards. Care should be taken to avoid any physical damage or shocks to the battery pack.
Should the battery pack become damaged, ensure that steps are taken to prevent dust and moisture
from entering the unit until the battery pack can be repaired or replaced.
4.2. Battery Charging
64062816 | 05 | 04/2016
The 64060625 intrinsically safe battery pack is designed to be very rugged and
reliable. If problems do occur, METTLER TOLEDO recommends that service be done
only by qualified, trained personnel. To assist in this repair, record as much
information as possible about what has happened including any error messages and
physical responses of the terminal and/or scale.
DO NOT USE THE BATTERY CHARGER WITHIN THE HAZARDOUS AREA. THE BATTERY
CHARGER IS NOT DESIGNED FOR NOR INTENDED FOR USE WITHIN HAZARDOUS AREAS.
DO NOT ATTEMPT TO OPEN OR REPAIR THE BATTERY PACK. THE BATTERY PACK IS NOT
FIELD SERVICEABLE OR REPAIRABLE. IN CASE OF FAILURE, RETURN TO FACTORY OR
DISPOSE OF PROPERLY.
Note that the 64050625 battery pack is shipped from the factory in a discharged condition.
Before use, the battery pack must be charged in the safe area for at least 6.5 hours.
Approximately every 30 seconds, the battery charger performs a temperature check of the
battery pack. During charging, if the temperature of the battery increases above 30˚ C (86˚ F),
METTLER TOLEDO NiMH Battery Pack Installation/Technical Manual
WARNING
WARNING
4-1