Emerson KEANE CF320BS00 Mode D'emploi page 7

3. Ceiling Fan Assembly
3.7
Route the two motor leads through the hanger ball
(Figure 7).
Reinstall the hanger ball on the downrod as follows:
Position the pin through the two holes in the downrod and
align the hanger ball so the pin is captured in the groove in
the top of the hanger ball (Figure 7).
Pull the hanger ball up tight against the pin and securely
retighten the Phillips head set screw in the hanger ball
(Figure 7).
A loose Phillips head set screw could create fan wobble.
3.8
The fan comes with black and white leads that are
80" long.
Measure up approximately 6 to 9-inches above top of
hanger ball/4.5" downrod assembly (Figure 8).
Cut off excess leads and strip back insulation 1/2-inch from
end of leads.
(Continued)
4.5" DOWNROD
PHILLIPS HEAD
SET SCREW
Figure 7
1/2-INCH
6 TO 9
INCHES
Figure 8
Please contact 1-800-654-3545 for further assistance
7
PIN
HANGER BALL
BLACK WIRE
WHITE WIRE
HANGER BALL
emersonfans.com
ETL Model No.: CF320