Care And Cleaning - Zanussi ZFT919Y Notice D'utilisation

It is recommended to leave the hood
operating for approximately 15 minutes
after cooking.
The control Panel is a sensor field.
Touch the symbols for 1 second to
activate the functions.
To operate the hood:
1. Turn on the appliance by pressing the
symbol.
You can now activate the functions.
2. To activate the function touch the symbol.
3. If needed, touch the light symbol
illuminate the cooking surface.
To turn off the appliance press the
again.
HOB TO HOOD FUNCTION
It is an automatic function which connects the hob
with a hood. Both the hob and the hood have an
infrared signal communicator. Speed of the fan is
defined automatically on basis of mode setting and
temperature of the hottest cookware on the hob.
You can also operate the fan using the hob
manually. The function can be activated from panel
of the hob.
For more information how to use the
function refer to the hob user manual.
ACTIVATING MAXIMUM MOTOR SPEED
When you press the button
Motor Speed starts to operate for 8 minutes. After

CARE AND CLEANING

CLEANING THE GREASE FILTER
Each filter must be cleaned at least once a month.
Filters are mounted with the use of clips and pins
on the opposite side.
To clean the filter:
While boiling and frying big quantities of food without a lid,
big humidity.
Refreshes the air in kitchen after cooking at a very low noise
level. It can be activated and de-activated by touching the
symbol. The function turns off automatically after 60 mi-
nutes. Use after cooking only.
to
symbol
, the Maximum
that time, the appliance returns to its previous
speed settings.
When the function is turned on,
additional touch on the button
does not have any effects.
ACTIVATING AND DEACTIVATING THE FILTER
NOTIFICATION
Filter alarm reminds to change or clean the charcoal
filter and clean the grease filter. The filter indicator
is turned on (white) for 30 seconds if the
grease filter must be cleaned. The filter indicator
flashes (white) for 30 seconds if the charcoal filter
must be replaced or cleaned.
Refer to filter alarm in care and
cleaning chapter.
1. Switch on the control panel.
2. Make sure that the icons are turned off.
3. To activate or deactivate the charcoal filter
notification touch
If the charcoal filter notification is
activated, the filter icon
(white) five times.
If the charcoal filter notification is
deactivated, the filter icon
(white) three times.
1. Press the handle of the mounting clip on the
filter panel underneath the hood (1).
for 3 seconds.
flashes
flashes
23