Scale Calibration; Calibration Configuration Settings; Calibration Menu - Brecknell MS-1000 Mode D'emploi

Scale calibration

Calibration Configuration Settings –
The scale is configured from the factory to match the specified settings for each unit, as defined by the product
specifications and sales brochure. Modification of the setting can be accomplished by altering user configuration
settings P7-P10. Caution: Calibration and/or configuration of calibration settings of your scale should be
accomplished by a trained service technician using certified weights to ensure proper operation and accuracy.
Calibration is not covered under warranty.
Setup Controls
Hold
Print
kg
Moves flashing digit
Config Avail.
Menu Settings
P7 00-31
P8 0,1,2
P9 0-5
P10 0, 1
Table 2a
You may choose to configure your scale for a higher resolution. The factory does not recommend increasing the
resolution above 7,500 divisions for a stable weight reading. Certain environments may cause the scale to be
unstable at factory settings, reduce the # of division settings to increase your stability.

Calibration Menu

Hold
Print
kg
Moves flashing digit
Calibration can be done with 25% to 100% of requested load and can be calibrated with 1 or 2 calibration points
Units
Change flashed digits
Default Definition
See table 2A Displayed Resolution
See table 2a Division Increment
See table 2a Decimal Position
See table 2a Calibration weight
Units
Change flashed digits
Tare
kg
Saves data and move down
to next Parameter setting
.
(00) = 500
(01 )= 600
(02 )= 750
(03 )= 800
(04) =1000
(05 )=1200
(06) =1500
(07) = 2000
0 = 1 ; 1 = 2 ; 2 = 5
0 = 123456 ; 1 = 12345.6; 2 = 1234.56 ;
3 = 123.456 ; 4 = 12.3456 ; 5 = 1.23456
0 = KG ; 1 = LB
Tare
kg
Saves data and move down
to next Parameter setting
.
On/Off
Zero
Exits setup mode
Detailed Setting
(08) = 2400 (15) = 7000
(09) = 2500 (16) = 7500
(10 )= 3000 (17) = 8000
(11) = 3500 (18) = 10,000
(12 )= 4000 (19) = 12,000
(13) = 5000 (20) = 15,000
(14) = 6000 (21-31) = N/A
On/Off
Zero
Exits setup mode