Ega Master 56586 Serie Mode D'emploi page 25

• Do not use damaged, frayed or deteriorated hoses and fittings. Make certain there are no
cracks, splits or leaks in the hoses.
• Use the quick connect system to attach the hoses to the tool and pump. Make certain the
spring-loaded retaining rings are fully engaged and the safety rings are tightly threaded
against the spring-loaded retaining rings to prevent the connectors from disengaging under
pressure.
• When connecting hoses that have not been preloaded with hydraulic oil, make certain the
pump reservoir is not drained of oil during start-up.
• Do not remove any labels. Replace any damaged labels.
The use of other than genuine the manufacturer replacement parts may result in safety
hazards, decreased tool performance, and increased maintenance, and may
invalidate all warranties. Repairs should be made only by authorized
personnel. Consult your nearest the manufacturer Authorized Service Center.
Refer All Communications to the Nearest The manufacturer Office or Distributor.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY
Do NOT exceed Maximum Pressure. See Torque Chart with Tool. Damage May Occur.
WARNING
Do not use damaged, frayed or deteriorated hydraulic hoses
and fittings.
Always wear eye protection when operating or performing
maintenance on this tool.
Always wear ear protection when operating this tool.
Do not carry the tool by the hose.
25