Replacing The Charcoal Filter; Replacing The Lamp - Zanussi ZFV919Y Notice D'utilisation

1
2
3. Slightly tilt the front of the filter downwards (2),
then pull.
Repeat the first two steps for all filters.
4. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
5. To mount the filters back follow the first two
steps in reverse order.
Repeat the steps for all filters if applicable.

REPLACING THE CHARCOAL FILTER

WARNING! The charcoal filter is non-
washable!
The time of saturation of the charcoal filter varies
depending on the type of cooking and the regularity
of cleaning the grease filter.
To replace the filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.
2. To install a new filter, perform the same steps
in reverse order.
In any case, it is necessary to replace the filters at
least every four months.
REPLACING THE CHARCOAL FILTER
The charcoal filter must be replaced if the filter
alarm is on.
Refer to the filter alarm in this chapter.
28
The time of saturation of the charcoal filter varies
depending on the type of cooking and the regularity
of cleaning the grease filter.
WARNING! The charcoal filter is
NON-washable! The filter cannot be
regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.
2. Turn the filter counterclockwise (1) and then
pull (2).
To mount the filters back follow the steps in reverse
order.
FILTER ALARM
Refer to activating and deactivating
the filter alarm in daily use chapter.
Refer to cleaning the grease filter in
this chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter (depends
on filter type).
To reset the alarm:
Touch the for 3 seconds.

REPLACING THE LAMP

This appliance is supplied with a LED lamp. This
part can be replaced by a technician only. In case
of any malfunction refer to "Service" in the "Safety
Instructions" chapter.
1
2