Before First Use; Filling The Water Tank - Espressions EM-1020 Mode D'emploi

English

BEFORE FIRST USE

Open the machine and remove all the plastic bags, boxes and papers protecting the different parts.
Never leave the plastic bags in reach of children.
Also remove any self-adhesive labels that may be on the product cover or any other information leaflets.
Remove detachable parts and clean in warm soapy water. Do the same with the other accessories.
Wipe the appliance body and stainless steel tray cover using a soft wet cloth.
IMPORTANT
Any action performed on the machine must be done with the power cord
disconnected. Never place parts or accessories in the dishwasher.
Never immerse the appliance, power cord or plug in any liquid.
Ensure that all parts are completely dry before re-assembling:
Place the cup rest grill on the water drip tray and slide into the housing.
Reposition the water tank by pushing it backwards towards the edge of the machine.

Filling the water tank

To fill the tank:
Remove the water tank by pulling it forwards using the central handle (fig.1) .
Fill the tank with fresh water without exceeding the maximum water level.
Return the tank into its housing by sliding it along the cup rest grill (fig.2) .
Ensure that you have pushed it right to the end.
Draining and priming of the water circuit
Before using the machine for the first time it is imperative that you allow the water to circulate through all
of the appliance's circuits to remove any possible air and for the pump to be activated.
With the water tank full:
Connect the power cord.
Check that the rotating control button is set to PENDING (
SELECTION button (h3) is at
Switch the machine on by turning the START/STOP button to the right to the (I) setting.
The TEMPERATURE light (h4) flashes slowly to indicate that the thermo block is heating up.
(Approximately 1 minute).
IMPORTANT
While the TEMPERATURE light (h4) flashes, none of the machine's functions can be used.
Place a sufficiently large enough container under the HOT WATER/STEAM spout.
When the TEMPERATURE light (h4) goes off, turn the rotating control button to the HOT WATER
(fig.3) .
function
The pump starts working at a steady rate and the hot water flows through the spout. Proceed with the
rinsing by circulating 1/4 of the full tank of fresh water through the spout.
Stop the flow of water by simply returning the control button to PENDING
NOTE
A little steam may be released from the water tank. This is completely normal.
12
.
) and that the TEMPERATURE
( ) (fig.4) .