Programming Instructions; Programming Overview - Nelson SmartZone EZ 8504 Guide D'installation Et De Programmation

PROGRAMMING INSTRUCTIONS

Programming Overview

Before programming the SmartZone
programming guidelines:
•
If a segment(s) on the LCD is flashing, it means that it can be changed by the user.
•
When using
•
Be sure the appropriate program letter is displayed when you are programming; program
changes are specific to the program letter displayed on the LCD.
•
There is no "ENTER" key. Key-presses and dial settings are stored automatically for you.
•
If you make a programming change while a program is running, the program terminates
immediately. The new program starts at the next start time scheduled.
•
When not running, the controller displays the current time and the current day.
•
During manual operations, there is a 10 second delay before the operation begins. During
this time, you can change your settings. Each time you make a change, the delay resets to
10 seconds.
•
MANUAL, CYCLE, and 3 MINUTE TEST procedures only operate with the Program dial set in
the AUTO position.
•
After a test procedure runs, the controller reverts back to the AUTO procedure and runs the
next program scheduled.
•
The test procedures ignore the sensor connection; this allows you to water or run your
program even if the sensor has suspended operation.
EZ, it may be helpful to become familiar with some general
TM
or keys, hold the button three seconds to start a fast scroll.
10