Rewind; Exposure - Reflecta Film Scanner Super 8 Mode D'emploi

Masquer les pouces Voir aussi pour Film Scanner Super 8:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
Note: Mac computers will create and add hidden files to SD/SDHC
memory card each time the user playbacks the recorded MP4 movie files
on the Mac. The hidden or modified MP4 files stored on the SD/SDHC
memory card can no longer be played back on the Film Scanner. A "No
File" message will be displayed on the Viewer instead.

Rewind

1. Open the flap door and remove film, then close the flap door. Check
and confirm the flap door is closed and not in the way of the rewinding
process to prevent film from being scratched.
2. Swap reels. Place an empty reel on the right shaft and place film
perforation holes on the outside (as shown). If any reel adapter is needed,
always place the grey adapter on the right side reel.
3. Follow the film routing diagram printed on the Film Scanner (the dotted
line) and follow the instructions on the screen.
4. Press the Enter button to Start/Stop the rewinding process.

Exposure

1. Exposure range is from 2.0 to -2.0.
2. Press Up/Down to change the value and press Enter to complete the
change selection.
3. The default setting is 0.0. Negative values provide a darker effect and an
Exposure of 2.0 gives the brightest result.
4. Adjust the required Exposure before recording.
Open
7
Remove Film From
Light Table Then
Swap Reels
Full(L) Empty(R)
GO
0.5
0
-0.5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Film scanner normal 8

Table des Matières