Turn On/Off The Film Scanner; Clean The Light Table; Mount The Reels And Film - Reflecta Film Scanner Super 8 Mode D'emploi

3. Turn on/off the Film Scanner

Press the power button to turn the Film Scanner on/off.

4. Clean the Light Table

Push the film door tab left to flip open the door. Use the included brush to
clean the light table very gently.

5. Mount the Reels and Film

a. If your film reel has a 8 mm (small) mounting hole, mount the reel
directly to the left shaft, otherwise use the provided red coloured reel
adapter. If adapters are needed, always place the red adapter on the LEFT
side; the GREY coloured adapter is for the RIGHT side.
Insert here
Left Reel Adapter (Red/No-Fin)
b. Mount the included 5" reel onto the right shaft.
c. Follow the Film Routing Diagram printed on the face of the Film Scanner
to route the film.
Right Reel Adapter (Grey/Finned)
4
EN
Insert here