Adjusting The Cold Water Temperature - vitapur VWD1076BLST Guide D'utilisation Et D'entretien

ELECTRONIC CONTROL PANEL FUNCTIONS
4
COLD WATER
1
ACTIVATION BUTTON
CHILD SAFETY
2
LOCK BUTTON
HOT WATER
3
ACTIVATION BUTTON
HOT WATER HEATING
ACTIVATION BUTTON
4
LED EMPTY WATER
5
BOTTLE WARNING
LED HALO LIGHTS
6
WARNING: Hot water temperatures can reach 94C/201F and produce severe scalding, never let
children dispense water without direct adult supervision.
Operation
1. DISPENSING ROOM AND COLD WATER

2. ADJUSTING THE COLD WATER TEMPERATURE

By turning the cold water temperature control (K) at the back of
²
the unit, (using a flat screwdriver) the temperature can be adjusted.
Turn the dial clockwise between High (cool) and Low
(colder) levels until the desired temperature is reached.
Note: If the water dispenser is not dispensing
water, there could be a possible ice build up due
to the control being set too cold. If this happens,
unplug the dispenser overnight and reset the
control to High and slowly increase based on your
use and need for cold water.
3
Touch the child safety lock button #2, wait for the beep and release, you
have 4 seconds to touch/activate the cold water button #1. Keep your finger
on the cold water button until the desired amount of water is delivered.
Child safety lock #2 must be activated, (unlocked) each time you draw hot
or cold water. Touch the button and wait for the beep and release, you have
4 seconds to make your water selection before they automatically re-lock.
Touch the child safety lock button #2, wait for the beep and release, you
have 4 seconds to touch/activate the hot water button #3. Keep your finger
on the hot water button until the desired amount of water is delivered.
You do not have to activate the child safety lock to initiate the hot water
heating function, simply touch the hot water heating button, a beep will
sound and the halo light will start flashing. Heating cycle takes approximately
3 minutes. When the halo light stops flashing, 4 beeps will sound and the
heating cycle is complete, hot water is now ready to be dispensed.
When the LED light in the center of the water bottle icon starts flashing, the
water bottle is empty. Replace the water bottle.
The halo lights surrounding the cold button #1 and hot button #3 will start to
flash during the heating and cooling cycles.
1
1
5
6
2
2
TEMP
Min.
High
1
2
3
3
Max. Low