Fracarro KM Instructions D'emploi page 13

5.5 HEADEND SETUP AND KTP EMULATION MENU
This menu concerns advanced programming that foresees the connection of several modules by RJ45 jumpers.
Procedure to modify the modulator address in the event of use of several modules connected to one another:
• enter the "SETTINGS" – "SET ADDRESS" menu;
• set the headend address number by using the arrows;
• on the TPE display, the word "Wait ..." will appear (the wait can last up to 0 seconds);
• scan the modules: SETUP HEADEND --> SCAN HEADEND;
• the TPE checks the modules present in the headend; when the number of installed modules is reached, press the "X"
key of the TPE;
• enter the "HEADEND SETUP" menu;
• save with the TPE "S" key.
Nav igation in the headend
programming menus
HEADEND
SETUP
(Not av ailable)
Automatic
acknowledgement of the
headend connected to
the TPE
Export the headend configuration to
another one. Av ailable only when
the module address is not 000
Restore the headend def ault
settings. The address of the
module is reset to 000.
Manual setting of the
headend address.
KTP
EMULATION
NAVIGATION
OSD NAVIGATION
HEADEND SCAN
COPY
FACTORY SETUP
SET ADDRESS
RESET MODULE
KTP Emulation
Emulation of the
KTP programmer
KTP
EMULATION
KM/KMM/KMS
KM/KMM/KMS
Search Module....
Copy Paste
KM/KMM/KMS
KM/KMM/KMS
All
KM/KMM/KMS
modules
KM/KMM/KMS
All
KM/KMM/KMS
modules
V=OUTPUT
1
Ref er to the general
programming menu of the
KM modulator
Automatic search of the headend or
connected dev ice. Af ter searching,
the main menu can be seen f rom
the NAVIGATION f unction.
YES=V NO=X
YES=V NO=X
Select the new address
Change address
by the up/down arrows.
Current: xxx
Conf irm by pressing
New: xxx
the V key .
YES=V NO=X
This f unction is not av ailable
f or the programming of the
KM modulator