SALCO SNP12 Mode D'emploi page 21

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The RETRO POPCORN MAKER™ is designed with
a retro appearance, however, it is a technologically
advanced hot air popcorn popper that pops more ker-
nels than many other popcorn makers.
This convenient tabletop-size electric popcorn popper
uses air instead of oil, producing perfectly popped pop-
corn with less kernels to bite into. Air-popped popcorn
is a deliciously healthy low-fat snack.
INSTRUCTIONS FOR USE
The RETRO POPCORN MAKER™ is easy to use. Just
follow these simple instructions.
After Taking the Unit Out of the Box
- Your RETRO POPCORN MAKER™ is already fully
assembled. Before first use, lift the top housing off
of the main body and wipe clean the inside of the unit
with a non-abrasive moist sponge or a non-abrasive
moist towel. Wipe dry with a non-abrasive towel.
- After cleaning the inside, put the top housing back
onto the base.
Now you are ready to enjoy freshly popped popcorn in
your RETRO POPCORN MAKER™!
Popping Popcorn
First, find a stable place near an electrical outlet before
starting. (Make sure your cord is away from any water
source. If needed, it is acceptable to use an extension
cord).
1. Fill the kernel cap on the top of the unit with your
favorite popcorn. It is
IMPORTANT - NEVER underfill or overfill the kernel
cap. Underfilling the cap can cause less kernels to pop
and more hard kernels to come out of the unit during
popping. Overfilling can cause popped popcorn to burn
and smoke as it will overfill the popping chamber. (If
you overfill the cap with kernels when filling, use your
finger to level off.)
2. Pour entire cap of kernels down the hole on the
top of the unit until cap is empty.
3. Place cap back in its place.
SNP12-IM.indd 21
4. Place a bowl or dish under the popcorn opening to
allow popcorn to fill the bowl.
NOTE: When selecting a bowl, make sure to use one
that is large enough and will fit under the popcorn
chute.
A.
5. Plug unit into outlet.
6. Turn unit ON (See illustration C showing ON/OFF
button) and in just minutes, you will have freshly pop-
ped popcorn to perfection!
7. When kernels have fully popped, turn unit OFF.
You can tip the popcorn maker forward at this point to
make sure you get all the popcorn out of the machine.
8. Eat popcorn as is or top with your favorite toppings
such as:
...and more recipe ideas next !
IMPORTANT - ALWAYS allow 10 minutes between
popping corn for machine to cool so unit does not
overheat and works effectively.
CLEANING
1. Allow unit to cool at least 10 minutes before lifting
the top housing to clean the unit.
(See Illustration A)
B.
C.
- Salt and Pepper
- Seasoning Salts
- Butter or Margarine
- Caramel
- Worcestershire Sauce
- Food Coloring for fun
- Parmesan Salt ...
EN
21
29/04/2015 17:37

Publicité

Table des Matières
loading

Table des Matières