Accessories; Service Information - Black & Decker LSW60 Mode D'emploi

with the nozzle several inches above
the ground. Slowly advance keeping the
accumulated pile of debris in front of you.
E
SWITCHING ON AND OFF
WARNING:
HANDS TO GRIP THE PRODUCT FIRMLY
WHEN SWITCHING ON.
CAUTION:
UNIT DISCHARGE AT SELF OR
BYSTANDERS.
• To turn the blower ON, squeeze the
variable speed trigger (1).
• Release the trigger to turn the blower OFF.
POWERBOOST FEATURE
The POWERBOOST feature (3) is located
on the tool handle as shown in figure F. It
allows you to optimize the tools performance
and boost the power as needed.
• Switch the blower ON.
• To activate the "Boost" mode, press the
POWERBOOST button. The POWERBOOST
LED (4) will illuminate, indicating "Boost" is
activated.
• To deactivate the "Boost" mode, press the
POWERBOOST button. The POWERBOOST
LED (4) will turn off.
• POWERBOOST will automatically disable
and the blower will return to "Normal" mode
when the variable trigger is fully released.
NOTE: Operate in "Normal" mode for
most blowing needs. (Longer runtime will
be achieved.) Activate "Boost" mode as
needed to clear heavy or wet debris.
F
3
4
USE BOTH
DO NOT POINT
8
DEBRIS SCRAPER
The debris scraper (5) is great for wet sticky
leaves. It allows you to scrape wet leaves or
heavier debris while operating the blower.

ACCESSORIES

Recommended accessories for use with your tool are
available from your local dealer or authorized service
center. If you need assistance regarding accessories,
please call: 1-800-544-6986.
WARNING:
not recommended for use with this tool could be hazardous.

SERVICE INFORMATION

All BLACK+DECKER Service Centers are staffed with
trained personnel to provide customers with efficient and
reliable power tool service. Whether you need technical
advice, repair, or genuine factory replacement parts,
contact the BLACK+DECKER location nearest you. To find
your local service location, call: 1-800-544-6986 or visit
www.blackanddecker.com
This Class B digital apparatus complies with Canadian
ICES-003. This device complies with part 15 of the
FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user's authority
to operate the equipment. This Class B digital
apparatus complies with Canadian ICES-003.
®
The RBRC Seal
The RBRC® (Rechargeable Battery Recycling Corp-
oration) Seal on the nickel cadmium, nickel metal hydride
or lithium-ionbatteries (or battery packs) indicates that
the costs to recycle these batteries (or battery packs) at
The use of any accessory