Maintenance And Care - JBL CristalPROFI greenline e402 Mode D'emploi

The following approximate capacities refer to a hose length of 1.5 m and operation with the
supplied filter media in a clean or new condition:
The filter media and hoses should be cleaned when these levels are reduced by about 50 %.

Maintenance and care

Caution: Regular maintenance and cleaning of the filter is vital to prevent a loss in the
pumping capacity.
All JBL CRISTALPROFI
media to provide clean and healthy aquarium water for "normal" operation. The filters pro-
vide extremely good conditions for the development of colonies of cleansing bacteria which
play an essential role in the breakdown of pollutants. Mechanical pre-filtering ensures that
these bacteria can efficiently carry out their task undisturbed for as long as possible.
You can of course adapt to your special needs by selecting from the wide range of available
JBL filter media. Depending on your choice of filter media, this may influence the pumping
capacity of your filter and the length of time the filter media can be used.
7
Cleaning or replacing filter media
Make sure to always disconnect the mains plug before carrying out any work on the
filter!
Turn the two small stopcock levers on the pump head to the stop position (●) opposite the
"OPEN" mark. Lift the middle lever on the hose connection block as far up as possible and
push to the stop position. This slightly lifts the hose connection block out of its seat. Pull
upwards to lift the hose connection block out. The ball valves in the hose connection block
are now closed and retain the water in the hoses. This prevents accidental opening e.g. by
children and any associated unwanted leakage of water.
Open the 4 locking clips on the filter canister and remove the pump head.
Remove the filter baskets with the filter media and rinse the filter media in lukewarm water
(25°C). Never wash ALL the filter media at the same time, as too many beneficial cleansing
bacteria would be washed away. The JBL CRISTALPROFI
so that, as a rule, only the pre-filter material (F1) has to be cleaned whilst the remaining filter
material must be cleaned at longer intervals.
CP e402: 200 – 250 l/h
CP e702: 350 – 400 l/h
CP e902: 380 – 450 l/h
CP e1502: 800 – 900 l/h
CP e1902: 1100 – 1200 l/h
©
greenline external filters are supplied with a standard filling of filter
©
filters of the e range are designed
de
en
fr
nl
it
sv
es
pt
pl
cs
ru
ro
tr
el
zh
25