•
The CALC light and the on/off button start
flashing to indicate that the descaling cycle
is in progress.
•
During the descaling cycle, the water comes
out of the machine in intervals.
•
When all the water in the water reservoir
has been used up, the descaling cycle is
finished. The on/off button starts to flash
rapidly.
8.2 Flushing after descaling
Rinse the water reservoir under the tap and
1
then fill it to the top with fresh tap water.
Notes:
D
• Do not place the BRITA MAXTRA filter
cartridge in the water reservoir.
• Do not refill the water reservoir with
used hot water or the used descaling
mixture.
Tilt the water reservoir and place the bottom
2
back onto the machine (1). Then press the top
of the water reservoir towards the machine (2).
Place the 1-cup pod holder q with a used
3
coffee pod in it in the coffee machine. Close
the lid and make sure it is properly locked.
Put a bowl with a capacity of at least 2 litres
4
under the spout to collect the water.
2L
Press the 1-cup button q and the 2-cup
5
button qq at the same time for 3 seconds
until you hear a beep to start the flushing
cycle.
Remove the used pod and clean the pod
6
holder after the flushing cycle to prevent the
sieve in the centre from getting clogged.
Repeat steps 1 to 6 to ensure a clean
7
machine.
After the descaling cycle and the flushing
8
cycles, the CAlC light goes out and the
machine switches off automatically. You can
now reinsert the BRITA MAXTRA filter
cartridge into the water reservoir.
19