Philips Senseo HD7873 Mode D'emploi page 16

To disassemble the coffee spout, grab the
5
two ridges of the inner part of the spout and
squeeze them lightly (1). Move the inner part
downwards to remove it from the outer part
of the spout (2).
Remove the filter holder from the water
6
reservoir and remove the BRITA MAXTRA
filter cartridge from the filter holder. When
you have finished cleaning all parts, you can
easily reinsert the filter cartridge into the filter
holder.
Clean the water reservoir, the filter holder, the
7
coffee spout, the coffee collector, the drip tray,
the cup tray and the pod holders in hot water
or in the dishwasher.
Caution:
C
Be careful not to damage the valve in the
bottom of the water reservoir if you use a
washing-up brush to clean the water reservoir.
16
Note:
D
Check if the sieve in the centre of the pod holder
is clogged. If this is the case, unclog the sieve by
rinsing the pod holder under the tap. If necessary,
use a washing-up brush to clean the sieve
Clean the lid of the water reservoir in warm
8
water, if necessary with some washing-up liquid.
Note:
D
The lid of the water reservoir is not
dishwasher-proof.
Clean the water distribution disc and the
9
rubber sealing ring with a moist cloth.
Caution:
C
Do not remove the rubber sealing ring and be
careful not to damage the tab on the water
distribution disc.
Clean the water inlet on the machine with a
10
moist cloth.