Re-Scan Digital Radio Stations; Display Station Information; Display Station Signal Strength; Cds - Bose WAVE SOUNDTOUCH IV Serie Notice D'utilisation

Masquer les pouces Voir aussi pour WAVE SOUNDTOUCH IV Serie:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 146
C D S

Re-scan digital radio stations

You can re-scan for available digital radio stations at any time
DIGITAL RADIO is selected. This capability is useful if you change the
location of the system or decide to connect the external antenna.
1. Press and hold
until AUTOSCAN appears on the display,
followed by PRESS PRESET 3 TO CONFIRM.
2. Press presets
.
The message, PLEASE WAIT SCANNING appears on the display
until scanning is done. When done, the first primary station
is played.

Display station information

There are three ways to display information about the currently
playing digital station:
Station name
(default setting):
Current program
content:
Program type:
To change the way station information is displayed, press Play Mode
until the type of information you want appears on the display.

Display station signal strength

For the current station, signal strength appears on the display as a
numeric percentage of full signal strength and its classification.
To view the signal strength of the current station, press and hold
Play Mode.
Signal
Classification
0 - 19
Low
20 - 39
Poor
40 - 79
Moderate
80 - 89
Good
90 - 100
Very Good
Note: If the station is UNAVAILABLE or OFF AIR, no signal strength
information is available.
1 4 - E N G L I S H

Play audio CDs

Insert the disc, label side up, into the CD slot below the display.
The disc player pulls the disc in and begins playing.
Note: On the remote, press
When a CD is playing, CD source information appears on
the display:
Selected source
Clock time
Play
mode
Track number
Button
Function
Toggle between playing or pausing audio.
• Skip to the beginning of the current track.
• Press twice to skip to the beginning of the previous
track.
Skip to the next track.
Press and hold to rewind through a track.
Press and hold to fastfoward through a track.
• Stop a CD.
Press again to eject a CD.
• Press and hold to eject a CD.
Notes:
• When you play a stopped CD it always resumes from the place it
was stopped.
• If you eject a CD but do not remove it from the CD player slot
within 10 seconds, the CD player pulls the CD back into the player
and reloads it.
CAUTION: Do NOT insert mini CDs or non-circular CDs into the disc
player. These discs may not play properly and could
interfere with the system's ability to eject them.
if the CD source is not selected.
Elapsed track time

Publicité

Table des Matières
loading

Table des Matières