Whirlpool WEG750H0H Manuel Du Propriétaire page 25

To Adjust Double Burner (On Some Models):
1. Light burner and turn to lowest setting where both inner and
outer burners are lit.
2. Remove the control knob.
3. Insert a 1/8" (3 mm) flat-blade screwdriver into the adjustment
locations shown in the following illustration and engage the
slotted screw. Turn the screw until the flame is the proper size.
Turning the screw clockwise will increase the flame size and
counterclockwise will decrease the flame size.
A. Control knob stem
B. Screwdriver
C. Pliers
4. Replace the control knob.
5. Test the flame by turning the control from the low position to
the high position, checking the flame at each setting.
Check Operation of Oven Bake Burner
Refer to the Quick Start Guide and online Control Guide for proper
operation of the oven controls.
Adjust Oven Bake Burner Flame (If Needed)
1. Remove the premium storage drawer, warming drawer or
baking drawer or storage drawer(see the "Remove/Replace
Drawer" section).
2. Locate gas pressure regulator at rear of the drawer
compartment.
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
3. Check the oven bake burner for proper flame.
a. Remove the oven racks.
b. To remove the oven bottom: Remove 2 screws at the rear
of the oven bottom. Lift the rear of the oven bottom up
and back until the front of the panel is away from the front
frame. Remove from oven and place on a covered
surface.
A. Screws
B. Oven bottom
c. Press BAKE.
d. Press the Start pad.
The oven bake burner should light within 8 seconds. If
unsuccessful, the oven bake burner will pause for 40
seconds then retry to light for another 8 seconds. It will try
for three entire cycles.
Electronic igniters are used to light the bake and broil
burners.
This flame should have a 1/2" (1.3 cm) long inner cone of
bluish-green with an outer mantle of dark blue and should
be clean and soft in character. No yellow tips, blowing, or
lifting of flame should occur.
4. If the oven bake flame needs to be adjusted, locate the air
shutter near the center rear of the drawer cavity behind the
access panel. Loosen the locking screw and rotate the air
shutter until the proper flame appears. Tighten locking screw.
A. Locking screw
B. Air shutter
5. Push the Off pad when finished.
6. Reinstall the oven bottom and the premium storage drawer,
warming drawer or baking drawer or the storage drawer (see
the "Remove/Replace Drawer" section).
25