Installing The Cover - Household Essentials StowAway Manuel D'installation

A. Lift the cabinet using your legs not your back,
and place in the cutout.
B. Rest the Ironing board cabinet (Part A)
on the drywall at bottom of the cutout and tilt
into place (see figure 1).
C. Drill 1-Phillips Drywall Screws (Part E) approx. 1"
below top shelf and 1-Phillips Drywall Screws (Part E)
approx. 1" below the second shelf. Repeat on other
side. This will secure cabinet to the studs in the wall
(see figure 2).
D. When ironing board cabinet has been secured to the
framing studs attach door by lining up hinge with
pilot holes and attach with 4-Phillips Panhead Screws
(Part G).
Figure 2
A. To install cover/pad pull board into place.
B. Place nose pocket over the nose of the board and pull into place.
C. Finish by fitting over the end of board.
NOTE:
Once your cover is in place, you may experience a stiff swivel. As you use your board the cover will begin
to mold to the board surface making your board easier to swivel.
This cover features a one piece construction, with a thick fiber pad, bungee cord binding and nose pocket
that allows for an easy installation and perfect fit. The cover has Household Essentials™ environmentally
friendly NANOMAX® stain and scorch coating, which has been certified by Cradle-to-Cradle.
6
INSTALLING THE STOWAWAY® IRONING BOARD

INSTALLING THE COVER

Figure 1