Household Essentials StowAway Manuel D'installation page 4

The StowAway® In-Wall Ironing Board fits between two 16" on center studs.
A. Locate the wall studs using a stud finder.
B. Measure 25" from the floor, using a level, mark a straight line across stud to stud. This will put
your ironing board surface at the standard height of 36", the height adjustment feature raises
the board surface to approximately 38". If you would like a different height range, adjust your
starting measurement from the floor up to the bottom of the cut out.
C. Measure from the top of your 25" line up 46 ¼".
Using a level, mark a straight line across stud to stud.
D. Use your level to draw a straight vertical line connecting the bottom line to the top line
resulting in a rectangle shape.
E. Using a Drywall Saw to cut along the
outline (14 ¼" x 46 ¼") exposing the
opening between the two wall studs.
F. If you are using a light kit
(SOLD SEPARATELY), stop and have an
electrical line dropped to the unit
by a CERTIFIED ELECTRICIAN. Light kit
installation instructions are found in the
light kit box.
A. Locate the marked holes on back side of the door (fig. 1)
B. Slide the lower section of 1– door hinge (Part D), into the door slot, laying the plastic part of
the hinge flush on the back side of the door.
C. Using 2-Phillips Panhead Screws (Part G) attach hinge to door.
D. Follow the same steps for second hinge.
4
PREPARING THE WALL FOR INSTALLATION
MOUNTING THE HINGES ON THE DOOR
Figure 1
14 ¼"
46 ¼"
25"
Figure 2