Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A. The cabinet door (Part B) may be attached to either side of the cabinet (left or right hinged).
Lay Ironing Cabinet (Part A) on side. See figure below.
B. Lay the cabinet door (Part B) beside the ironing board cabinet (Part A) as shown in
figure below with both hinges fully opened. Slide the door toward the cabinet so that the hinges
extend inside. Notice that each hinge has two small "stop guides" (see figure below). The stop
guides should rest against the front edge of the cabinet and stop the hinge from going further.
C. Mark the location of the hinge's mounting holes on the cabinet frame with a pencil.
Using a 3/32" bit, drill pilot holes 1/2" deep into the cabinet frame for each mounting hole.
D. DO NOT INSTALL DOOR* - When ironing board cabinet has been secured to the framing studs
attach the hinges to the cabinet using 4-Phillips Panhead Screws (Part G).
* This makes the ironing board cabinet much lighter and easier to install.
A. The placement of the hook is determined by how the door is hinged (left or right).
Left Hinged = (see fig. 1) Mount hook 6" from the top edge and ½" from side
edge of the door. This will leave adequate room if you choose to install the light kit.
Right Hinged = (see fig.2) Mount hook 2" from the top edge and ½" from side edge of the door.
1/2"
6"
MOUNTING THE DOOR TO THE CABINET
INSTALLING THE GARMENT HOOK
Door
Figure 1
Left Hinge
Cabinet
Stop Guides
1/2"
Door
Figure 2
Right Hinge
Door
2"
5
Publicité
Table des Matières
