Wired Connection - THOMSON 512396 Mode D'emploi

C - iNSTALLATiON
2.2 - WIRED CoNNECTIoN
If you do not want to use a wireless connection, connect your camera to the Internet using an RJ45 network
cable.
Modem/router
connected to
the internet
IMPoRTAN T: Do not connect your camera to your computer. This will not provide it with access to the
internet.
In most cases, the camera is immediately detected by the modem/router, which grants it access to the
Internet. After a few seconds, the camera's network activity LED should flash.
Note: if you want to use your camera with WiFi but cannot use either the WPS function or the EzLink
function, set it up with a wired connection so that you can then move to a wireless connection.
10
en
Motorised 1080p ip Wi-Fi caMera
camera
Mains adapter