Connection And Operation; Remote Control; Control Elements - Dynaudio Xeo Manuel Du Propriétaire

On Off Volume
Input
1 2 3
Transmitter
A B C
16

Connection and operation

This section describes the connections and control elements for the Xeo components. Examples on
various options, such as where to locate the transmitter and loudspeakers and which signal sources
can be connected, can be found starting on page 5. If the variant you need is not included or if you
have problems with connection and commissioning, please contact your Dynaudio Xeo distributor.
Distributor addresses can be found in the Internet at www.dynaudio.com.
Note: Depending on the product package purchased by you, it is possible that your package may not
contain all of the described components.

Remote control

The Xeo remote control can be used to turn the loudspeakers on and off, change the volume, and
select a transmitter and its connected signal sources. If the loudspeakers are being operated in stereo
mode (right/left), commands will always apply to both of the loudspeakers.

Control elements

On/Off On/off switch
Switches the selected loudspeaker on and off.
Mute
Mutes the selected loudspeaker.
Volume Volume
+ = Up
– = Down
Input Signal source selection
1 / 2 / 3 Selects one of three signal sources from the active transmitter.
Transmitter Transmitter selection
A / B / C Selects one of three transmitter channels.
Dynaudio