Whirlpool WEG730H0DS0 Fiche Technique page 10

FOR SERVICE TECHNICIAN'S USE ONLY
CODE WHAT IS IT?
F6E1 Over Temp
Oven temperature is greater than 601°F (316°C).
The affected oven will be locked out until the control
detects an oven temperature less than 601°F
(316°C).
WHEN CAN IT OCCUR? RECOMMENDED CORRECTIVE ACTION PROCEDURE
Within 60 seconds of the 1.
control detecting an over
temperature condition.
If oven is
Warm
Warm
Room Temperature
Room Temperature
2.
3.
4.
5.
6.
7.
10
Enter Diagnostics Mode by pressing
CANCEL>CANCEL>START within 5 seconds. Oven
temperature is displayed on the screen. Manually check
oven for heat.
and temperature reading is
Near 600°F (316°C)
Room Temperature
Near 600°F (316°C)
Room Temperature
Unplug range or disconnect power. Inspect control board
connector P10 for a backed out terminal or loose connection.
If found, reconnect or replace harness and go to Step 5. If not,
go to Step 3.
Disconnect control board connector P10. Measure resistance
across P10-3 and P10-4 (main oven) and P10-1 and P10-2
(drawer). At room temperature, the thermal sensor should read
between 1000Ω and 1200Ω . Reconnect P10. If test results
are good, replace the control board, and go to Step 5. If
results are not correct, go to Step 4.
Disconnect the oven sensor from the wiring harness and
measure resistance across the sensor terminals. Resistance
reading should be between 1000Ω and 1200Ω. If test results
are good, replace the wiring harness between the sensor and
the control board, go to Step 5. If test results are not correct,
replace the sensor and go to Step 5.
Replace all parts and panels before operating.
Plug in range or reconnect power.
Verify operation is normal. Enter the diagnostic mode to view
the "Faults" screen. Press START TIME or DELAY START to
clear each Fault code(s).
go to
Step 2
Step 4
Step 4
Step 5