Haier HD90-A2979 Mode D'emploi page 25

EN
11.6 Reversing the door swing (Only for 8/9kg models)
Before you start, unplug the dryer from its electricaloutlet.
Handle parts carefully to avoid scratching paint.
Provide a non-scratching work surface for the doors.
Tools you will need: Phillips-head screwdriver.
Once you begin, do not move the cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from the right side to the left side.
If you ever want to switch them back to the right side, follow these sameinstructions
and reverse all references to the left and right.
1. Remove the door assembly
Open the door. Remove the two screws holding the-
hinge/door assembly to the dryer. Carefully set the
hinge/door assembly aside (Fig. 11-4).
2. Remove, rotate and replacethe inner door
Remove the eight stickers and screws securing the
inner door to the outer door. Remove the inner door,
rotate it 180° and reinstall it into the outer door using
the same eight screws and stickers (Fig. 11-5).
3. Remove, rotate and replace the door lock & strike
plate
Remove the two screws holding the strike plate, and
then remove one screw of the door lock, push down
and take out the lock rotated 180° and install it on the
opposite side. the same eight screws and stickers (Fig.
11-6).
4. Rotate and replace the hinge/door assembly
Remove the two screws holding the strike plate, and
then remove one screw of the door lock, push down
and take out the lock rotated 180° and install it on the
opposite side. the same eight screws and stickers (Fig.
11-7).
11.7 Wash-dryer stack
The arrangement to a space saving wash-dryer stack
is possible (Fig. 11-8). Not every washing machine is
suitable for this purpose. Information, as well as the
corresponding mounting kit are available via your local
dealer.
The mounting instructions supplied with the kit care-
fully inform about the installation steps.
11-Installation
screws and stickers.
Remove the
Remove eight
Inner door and
stickers and
rotated 180
screws
as shown
side.
Strike Plate
and Screws
1.Push
down
2.rotate an
angle then
can take
out
11-4
Hinge and Door
Assembly
Hold the Door and
Remove Hinge Screws
from the Dryer
11-5
Replace the
inner door with
o eight screws and
stickers
Replace
the Door lock
and then
Reinstall
Strike Plate
and Screws
11-6
Secure with same
two screws
11-7
11-8
25