Publicité
Les langues disponibles
Les langues disponibles
The counter at the top left corner
displays the memory left for
further races. Further races can
be recorded by pressing A and B
buttons as above.
** Since 5 memories are used for
memorizing the date and number
of the race, the memory left will
be 1993 as shown below.
Press D to recall data stored. The
display which we call the RACE
RECORD is as shown in Fig. 8.
The display shows the date in
which the race was recorded and
MCH-001(MSP for SPEED mode)
stands for the first race recorded
in LAP/SPLIT mode at that date.
** Pressing B button when the
stopwatch is displaying the
RACE RECORDS will show the
next RACE RECORD (if there is)
and the LAP TIMES in this
RACE RECORD can be recalled
by pressing D.
** Pressing and hold A button when
the stopwatch is displaying the
RACE RECORDS will clear the
memories in that race record (
when the contents in this race
record are cleared the display will
show CLEARED and sounds a
long beep, if A is released before
ED appears the memories will not
be cleared ) and continuously
holding A button after this will
clear the memories of all races
(display will show ALL
CLEARED and display will return
to as shown in Fig. 2. Memories
are available for storage when
they are cleared.
Press D again to recall the 1st
LAP data, as shown in Fig.9.
Fig. 7
Press D to recall the 2nd LAP
data, as shown in Fig.10.
Press D again shows the stopped
time, as shown in Fig.11.
Press D again to show the average
LAP time, as shown in Fig.12.
Fig. 8
Press D again to show the Best
LAP time, as shown in Fig.13.
AVERAGE calculation and BEST
record do not take into account
the last section of time before
STOP. Therefore, in order for the
stopwatch to keep track of the
average and best records of all
Laps, always use the B button
until the end of the race.
Pressing D again will go to the
next race records or return to the
1st race
records (if there is no further
race).
In the CHRONO MODE before
the start of a race, such as in
Fig.7, push and hold B for 2
seconds will go to the SPEED
SET mode as is shown in Fig.14.
Fig. 9
The first digit in the lowest row is
flashing to indicate setting of the
thousandth digit of distance.
Push A to set and B to select the
next digits. The highest setting
for distance is 9999.999.
After the digits are set press B
again to set the TIME unit with
the
top
HR flashing.
HR
(for
/hour),
Fig. 10
/minute) or SEC (for/second).
When the distance and time unit
are set, press C button to return
to the SPEED MODE (Fig. 15).
(Pushing C button anytime during
the setting will return to the
Fig. 11
Fig. 12
Fig. 14
Press A to start, the display is as
shown in Fig.16.
Fig. 13
** The
Press B to get the 1st LAP time
at the top row and the speed at
the middle row, as shown in
Fig.17.
If
distance is set to 200 meters and
time unit set is in seconds, the
speed calculated from a LAP time
of 17.09 seconds is 11.70 m/sec.
Using the B button the LAP times
and their corresponding speeds
can
be
displayed.
operations in the SPEED mode
are the same as that in the
LAP/SPLIT mode.** BASE 3
STROKE/FREQ -- if the distance
left
corner
Use A to set to
MIN
(for
SPEE
D
mode
).
Fig. 16
for
example
the
Recall
Publicité
