Assembling Handle; Assembling Cordwrap; Assembling Frame And Wheels - HeatStream HS-45-KFA Manuel De L'utilisateur Et Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MODELS HS-45/70T-KFA ONLY
- Tools required: Medium phillips screw driver.

ASSEMBLING HANDLE

1.Align the holes in the upper housing with the 2 holes in the
handle as shown in Figure 6.
2. Insert and tighten screws securely with screw driver.
Handle
Figure 6: Attaching Handle for models HS-45 /
70T-KFA

ASSEMBLING CORDWRAP

1. Insert tabs on cordwrap into slots in shell support, lining up the
holes on the cordwrap with those on the side cover.
2. Insert and tighten screws securely with screw driver.
MODELS HS-125T/175T/215T-KFA ONLY
- Tools required: Medium phillips screw driver, 5/16" open end
or adjustable wrench, needle nose pliers.

ASSEMBLING FRAME AND WHEELS

1. Slide axle through holes in wheel support frame. Slide wheel
bushings and flat washer (A) on to each end of axle.
2. Slide wheels on to each axle, being sure that the valve stem (if
pneumatic) is to the outside (see Figure 7.).
3. Attach wheel nut to threaded axle and tighten.
4. Place heater on the assembled frame, making sure that the air
inlet end is by the wheels, and the mounting holes on the tank
flange of the heater align with holes in frame.
5. Take the front handle and align the mounting holes with the
corresponding holes in the tank flange/wheel frame. Slide a
screw (A) through the holes and loosely attach a nut. Repeat
for the other 3 holes, then fully tighten all 4 screws and nuts.
6. Repeat this process with the rear handle
NOTE: The front handle is longer than the rear handle.
© 2012, Pinnacle Products International, Inc.
Assembly (Continued)
Screw
.
ASSEMBLING CORDWRAP
1. Align holes in cordwrap with corresponding holes in rear
handle. Insert screws (B) through holes, attach nuts and
tighten (see Figure 7.).
Figure 7 Attaching Handle for models HS-125T /
175T / 215T-KFA
Do not operate heater without support
CAUTION
frame fully assembled to tank.
6
Kerosene User's Manual
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Hs-70t-kfaHs-125t-kfaHs-175t-kfaHs-215t-kfa

Table des Matières