Invicta P642151 Manuel D'utilisation page 66

Ignition
7.5
Turn the appliance on by setting the switch on the side of the device to "1" (see section 1.2). The control panel will
confirm that it is switched on by displaying the main page ([OFF] message on the screen).
For initial commissioning or after an alarm due to a lack of pellets: it is important to know that the fuel
supply auger is empty. You must wait to allow the filling and then the supply to the burner.
To avoid this inconvenience (usually accompanied by a "failed" ignition sequence), pre-load the auger, press
[P1] and [P2] simultaneously or use the MENU 06 [INITIAL LOAD] from menu 06 (see section 2.9.6).
Note:
o For the first commissioning, TWO pre-loads are necessary.
o After an alarm due to a lack of pellets (PELLETS EMPTY), a pre-load is necessary.
o Pre-loading can be interrupted by pressing [P4], especially if a large amount of pellets starts to fall
into the burner.
The display shows the time, room temperature, set operating power
and operating status of the appliance.
To turn on the appliance, press and hold the [P4] key. The start-up
information is indicated on the screen by the [TURN ON] message.
Any issues during the start-up phase are indicated on the screen and an alarm will sound (see sections 2.10 and 4).
When the ignition is switched on, the operating status will proceed as follows: [PELLET LOAD], [PR FLAME].
Once the appliance has reached a sufficient level of combustion and
the warm-up period has been prolonged long enough, it goes into
working status which is the normal operating status. The screen
displays a message regarding the [WORKING] status.
At programmed time intervals, the appliance is set to the "cleaning"
operating mode to keep the burner clean and maintain its efficiency,
showing [STOVE CLEANING] on the screen.
SP 06 04 2018
Poêle Cannelé Plug-in
Références P642151 & P642152
Page 19 sur
47