Invicta P642151 Manuel D'utilisation page 107

Step 7: attach the connection tube to the hopper
Step 8: Make the seal between the heating element and the hopper
AN 6421501- DT 07.06 .17
A- Rotate the connection
tube and line it up with the 2
threaded ends
B- Line up the MS nuts with the
threaded end pieces
C- Visually check that the
tightness of the assembly
A- Lower the sealing ring as far as
possible on the heating element
diffuser tube
B- visually check the tightness of
the assembly
The silicone ring should cover the
connection beween the hopper
tube and the heating element tube
Page 6 - 8