Invicta P642151 Manuel D'utilisation page 106

Step 6: Attach the stove to the hopper
AN 6421501- DT 07.06 .17
Warning, make sure there is a protective ground cover if necessary.
4 assembly nuts
Extractor support
remove the 4 assembly nuts from the hopper extractor
1-
holder
2- check that the connection joint is in place
3- Slide the heating element against the hopper by lining it up
with the 4 screws of the extractor holder
4- replace the 4 nuts and tighten them with an 8-point fork.
Seal
4 connecting screws
Page 5 - 8