ETQ TG4000 Manuel D'utilisation page 9

ETQ
EASTERN TOOLS & EQUIPMENT INC
Attach Handles
The handles attach to the same end of the generator as the feet. To attach the handles to the
generator, perform the following steps:
1. The handle assembly consists of the handle, two bolts, and two nuts as shown in figure 6.
2. Line up the holes on the handle bracket, with bolts attached, the holes on the generator frame.
Fasten it tightly with wrench.
3. Secure the handle to the frame using the bolt and nut. Make this attachment so that the nut is on
the inside of the frame.
4. Fasten the bolt of the movable part.
5. Repeat steps 1-4 for the other handle.
Tel: (888)908-6200
Figure 6 - Handle assembly
6
Web Site: easterntools.com