Rowenta Pro Precision Mode D'emploi page 9

s steam is very hot: never attempt to
remove creases from a garment
while it is being worn, always hang
garments on a coat hanger. For fabrics
other than linen or cotton, hold the iron
a few inches from the garment to avoid
burning the fabric.
7 • Dry ironing
Do not pull the steam trigger.
8 • Fill the water tank again
When there is no more steam and
the"Water tank empty" light flashes:
water tank is empty (fig.9). Unplug the
unit from outlet. Open the water tank
cover and fill with maximum 33 oz/1L of
water (fig.1).
Take care not to overfill the tank.
If this occurs, remove the excess water
by tipping the unit.
Close the water tank cover. The "water
tank empty" light will be flashing. Press
the "Restart" button
of the unit. The Pro Precision steam
station is ready to iron when the steam
ready indicator light is steady green and
the iron temperature control dial light
has gone out.
9 • Storing your Pro Precision
steam station
Unplug the unit from outlet. Place the
iron on the iron rest. Fold the steam cord
tuck it in its housing (fig.17).
Wind up the power cord and secure it
with the velcro (fig.18). llow the iron to
cool down for 1 hour before storing it in
a cupboard or confined space.
(fig.10) on the rear
M INTEN NCE ND
CLE NING
10 • Cleaning the Pro Precision
steam station
The Iron soleplate:
In normal use a coating may build up on
the soleplate (starch, detergent buildup,
or burnt synthetic fibers). This can be
easily removed by using the Rowenta
Soleplate Cleaning Kit or a quality hot
iron soleplate cleaner available at many
stores and on line.
To prevent scratching the soleplate, do
not iron over sharp objects (zippers, etc.).
Do not place the iron on rough surfaces,
e.g. metal iron support, which may
scratch the soleplate.
lways put the iron with the soleplate
down on the iron rest, never place on its
heel, on the iron rest
The Base Unit:
Clean the plastic parts of the appliance
occasionally with a soft cloth.
11 • Easy descaling of the
Pro Precision steam station
Do not use any descaling substances
(vinegar, industrial descaling products,
etc.) when rinsing the scale collector :
they could damage it. Before descaling,
ensure that the appliance is unplugged
and that the soleplate and the iron rest
have cooled down for at least 2 hours,
in order to avoid any risk of scalding.
To extend the life of your Pro Precision
steam station and avoid scale in your iron,
your product is equipped with a built-in
scale collector. In geographies with hard
water, a scale of calcium may build up
inside the boiler.
preformance of the Pro Precision steam
station and may deposit white substances
on garments. This scale collector, located
in the boiler, automatically collects the
scale that forms inside.
6
That can effect
EN