Turning On And Off; Operating The Control Panel; Vertical Steam Ironing - Rowenta Pro Precision Mode D'emploi

USE
3 • Turning on and off
The water tank can be filled at any time
during use. When refilling take care not
to overfill the tank.
Plug the Pro Precision steam station into
a 120 volt electric outlet
automatically turn on.
The iron light will turn on and the steam
ready light will flash
Precision steam station is in use, the
electric pump will make a humming noise
as it pulls water into the boiler to produce
steam. This noise is normal. The Pro
Precision steam station is ready to use
when the steam ready indicator light
stops flashing,
minutes).
During ironing the temperature indicator
light for the iron will turn on and off. This
is normal as the temperature is being
regulated. The unit is still on when this
light goes out.
4 • Operating the control
panel
• Flashing green light: the water is
heating up in the boiler (fig.4)
• Continuous green light: steam is ready
for use (fig.6)
• Continuous red light: the water tank is
empty (fig.9).
• Orange « Calc- way System » light
flashes you must rinse
collector (fig.11).
5 • Using your Pro Precision
steam station
Place the iron's temperature control
(fig.5) to the type of fabric to be ironed -
see table below. The iron temperature
control light turns on.
While ironing, the light on top of the iron
will turn on and off, as the temperature is
maintained without interrupting ironing.
To obtain steam, press on the steam
trigger beneath the iron handle and keep
it pressed (fig.7). The steam will stop
when you release the trigger.
(Fig. 3) and it will
(fig. 4). When the Pro
(approximately
your scale
If using starch always spray it on the
reverse side of the fabric to be ironed.
Table 1
T
YPE OF F BRIC
S
YNTHETICS
(Polyester, cetate,
crylic, Polyamide)
S / W
ILK OOL
C / L
OTTON INEN
Recommendations: To prime the
steam circuit, either before using the
iron for the first time, or if you have
not used the steam function for a few
minutes, press the steam trigger
several times in a row, holding the iron
3
away from your clothes.
Iron temperature control setting: Start
with fabrics to be ironed at a low
temperature and finish with those
which need higher temperatures. Each
time you change fabrics, wait for the
light to turn off. Mixed fiber fabrics: set
the ironing temperature to the setting
for the most delicate fabric. Woollen
garments: pull repeatedly the steam
control trigger to obtain short bursts of
steam, while holding the iron one inch
from the garment. This will avoid
making the fabric shiny. For delicate
fabrics, pull the steam trigger (under
the handle of the iron) intermittently to
avoid possible water droplets appearing
with the steam.
Do not place the iron on a metal
support. lways place the iron on the
iron rest of the unit. It is equipped with
non-slip pads and has been designed to
withstand high temperatures.
6 • Vertical steam ironing
Set the iron temperature control to the
maximum position. Hang the garment on
a coat hanger and hold the fabric slightly
taut with one hand. Pull repeatedly the
steam trigger (beneath the iron handle)
moving the iron from top to bottom
5
S
ETTING
TEMPER TURE CONTROL
•
• •
• • •
(fig.8).