Publicité
Les langues disponibles
Les langues disponibles
13. Frequently asked Questions (FAQs).
Q: I just completed the installation of a Keyless Entry Deadbolt unit on my door; I am unable to
operate it manually, although I checked for smooth bolt operation during installation. What should I
do?
A: You need to run the "Bolt Direction" routine again; allow the process to run to completion see
Section 8 in User's Manual.
Q: Sometimes, when I operate the lock manually, I "feel" a bump while turning the turn-piece.
A: On installations where door alignment is less than optimum (Latch and strike do not quite
line up) the Keyless Entry Deadbolt may not be able to FULLY extend (or retract) the bolt when
commanded to do so. This causes the electro-mechanical components to go out of sync. To re-
synchronize the system, perform the following:
1. Have the door repaired and aligned properly
2. On the Keyless Entry Deadbolt unit push the "Lock" button
3. On the Keyless Entry Deadbolt unit enter code to unlock
4. The unit is now synchronized
Q: How long will the Keyless Entry Deadbolt operate on a set of batteries?
A: Based on 15 operations per day, a single set of Alkaline batteries will operate the Keyless Entry
Deadbolt for over a year.
Q: What type of batteries do you recommend?
A: For best results, use new non-rechargeable Alkaline batteries only.
Q: I just installed a Keyless Entry Deadbolt on my door but it does not operate correctly
A: This is probably due to incorrect or incomplete initialization. Please perform the following:
a. Remove the battery pack
b. On the Interior unit, press "Program" button three (3) times
c. Wait at least 10 seconds
d. Refer to section 8, "Bolt Direction Determination".
Q: I removed the battery pack momentarily and my lock does not work any more.
A: The system did not initialize properly due to remaining charge. To correct perform the following:
a. Remove battery pack
b. Press "Program" button three times
c. Wait 10 seconds.
d. Insert battery pack.
e. The system should flash the Green LED and beep, indicating proper
initialization
f. Repeat a-d if initialization failed
Q: I am planning to be away for several months; will my lock operate when I get back?
A: When the system is idling, it consumes minimum power (very close to battery shelf life.) With alka-
line batteries, the lock should be operable after years of idle. See also Questions and Answers below.
Q: I replaced my batteries less than a year ago and need to replace them again.
A: Check door alignment. If the Keyless Entry Deadbolt makes several attempts to lock or unlock
the door, it may mean that the door is warped or it does not line up correctly with the strike. Oper-
ating the lock multiple times reduces battery life. Avoid turning on the keypad light unnecessarily.
Q: What settings should I use to get the maximum battery life out of my lock?
A: Set "Status LED" (SW1) and "Auto-lock" (SW2) to the off position.
For assistance or warranty information: call
This product is covered by one or more of the following patents or patents pending: 5123683 5317889 5335525 5335950 5441318 5452928 5482335 5490700 5496082
5513509 5513510 5529351 5540070 5570912 5662365 5761937 5810402 5816629 5857365 6058746 6128933 6151934 6398465 6401932 6412319 6443504
6532629 6536812 6568727 6598440 6662606 6695365 6702340 6745602 6828519 6860131 6860529 6862909 6871520 6880871 6948748 6951123 6959569
6971513 6973813 7007528 7100408 7104098 7114357 7117701 7152891 7156432 7162901 7213429 7234331 7308811 RE38693 D344011 D347564 D348602
D348821 D352888 D361488 D361489 D361706 D363872 D373063 D373523 D400777 D407292 D431443 D435423 D436933 D437216 D437771 D443194 D443808
D446122 D447927 D452131 D453897 D453898 D453899 D454049 D458839 D461700 D463968 D464565 D464877 D465989 D468636 D472794 D473780 D514921
D524630 D525512 D525516 D540140 D540147 D541621 D542115 D545169 D547830
or visit, www.baldwinhardware.com
USA & CANADA
1-800-566-1986
9
Publicité
