Baldwin 8252402AC1LH Manuel D'installation Et De Programmation page 3

4. Install Interior Mounting plate.
a. Carefully insert the connector of the wire harness - through the center hole of the
mounting plate (see figure 8).
Fig. 8
Mounting
Connector Plate
b. Important, once the connector has passed through the center hole, tuck the
wire harness out of the way by pressing it into the notch hole as shown in figure 9.
c. Slide wires through the notch until mounting plate sits flush against door.
d. Making sure that exterior assembly and cylinder are pressed flush
against exterior door, with Baldwin cylinder logo horizontal, insert mounting
bolts and tighten.
e. Check the vertical alignment
for mounting plate and exterior
assembly. (See figure 10.)
f. Test. Using the key, retract and
extend the bolt a few times to test
for smooth action.
g. If action feels rough, loosen the
screws and re-align the mounting
plate and the exterior assembly.
h. Repeat as required.
5. Attach the Connector to the Interior Assembly.
Top view
Connector
Connector Port
Important Note: To prevent damage, always handle the wire harness
at the connector (do not pull wires).
a. Align the connector with the connector port of the interior assembly,
matching notch to slot.
Fig. 9
Fig. 10
KEEP PARALLEL
horizontal
Interior
Assembly
Notch
Hole
Bolt
Connector
Slot
Notch
Continued
3