Publicité
Les langues disponibles
Les langues disponibles
1. Install latch and Strike.
a. Determine your backset, see
figure 1. (Note: Latch is shipped in
the 2-3/8" back set.)
b. Extend bolt. If a 2-3/4" (70mm)
backset is required adjust latch as
shown. (See figure 2).
c. Install latch in the upright posi-
tion, securing with small wood
screws (see figure 3).
d. Install strike and components as
illustrated. 1) Dust Box, 2) rein-
forcing strike, 3) wood screws, 4)
3" wood screws, 5) face plate, 6)
finished screws (see figure 4).
2. Remove cover and battery case.
a. Remove cover from
assembly by sliding
cover up and off, see
figure 5.
b. Remove the battery
case from interior as-
sembly by lifting the
case up and out and set
aside, see figure 6.
c. Rotate turnpiece to be
horizontal, see figure 7.
3. Install Exterior Assembly.
a. Place adapter on door as shown.
b. Insert cylinder into exterior
assembly. Ensure torque
blade is vertical.
c. Place assembly on door,
threading the wire harness
through adapter and under
the latch.
2
Fig. 1
Fig. 3
Fig. 5
Fig. 6
Route wire
under bolt
Adapter
For 2-1/8"
diameter only.
Fig. 2
Top
Latch is shown in the
upright position
2-3/8"
(60mm)
or
2-3/4"
(70mm)
Fig. 4
Fig. 7
Cam
Torque Blade
(Shown vertical)
Wire Harness
Publicité
