Baldwin 8252402AC1LH Manuel D'installation Et De Programmation page 4

5. Continued.......
b. For easier orientation, view the alignment of connection from the top of
the interior assembly.
c. Once aligned, push the connector in firmly to connect.
6. Install Interior Assembly.
a. Making sure wires are clear of pinching and wire harness is routed as
shown, place the interior assembly on door, aligning torque blade inside
the turnpiece shaft.
Note: Turnpiece may be difficult to turn until step 8 "Automatic - Bolt
Direction Determination" is completed.
b. Once flush on door, insert and tighten small screws to secure assembly onto
the mounting plate.
Note: To aid insertion of screws, approach the screw holes with the screw loaded
onto the screwdriver.
Turnpiece
Shaft
4
Route wires down - avoiding any
excess bulge at curve, which could
interfere with battery pack installation.
Wire Harness
Small
Screws
Torque Blade