General Warnings; Sulfur Vaporizer Warning - Autopilot HYDROFARM ECLIPSE F60 Mode D'emploi

1 Save the instructions These safety and operating instructions must be kept in a safe place for
future reference
2 Heed all warnings All warnings on this product and in the instructions must be observed
closely
3 Follow all instructions All operating instructions must be followed
4 If the instructions as provided by the manufacturer are not followed, damage to the product
itself may result
5 Install your controller at least eight feet away from any devices that produce large amounts of
electronic noise, such as electronic ballasts or ozone generators
6 Do not exceed the maximum power rating (120V/145A in) and do not plug in a device/devices
requiring more than the max output current (145A)
7 Insert only NEMA 1-15P and NEMA 5-15P plugs into the receptacle on this device Do not insert
any other type of plug into it
8 Do not use this controller near water It is neither waterproof nor shockproof
9 Do not use the device near any heat source
10 Install this controller at least 8' away from any devices that produce large amounts of electronic
noise, such as electronic ballasts or ozone generators
11 This product is a Safety Class I Controller Its main plug should only be inserted into power
outlets that are properly grounded
If a sulfur vaporizer is used, first remove the remote sensor unit from the affected area or turn
the controller off and cover the remote sensor probe with a protective plastic bag. Remove
the bag before turning the power back on. Failure to protect the sensor while using a sulfur
vaporizer will result in damage to its infrared component and will void the warranty.

GENERAL WARNINGS

8' (2.5 m)
minimum

SULFUR VAPORIZER WARNING

10