Klarstein PASSIONATA ROSSA 20 Mode D'emploi page 19

USE
BEFORE THE FIRST USE
To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with
warm water as follows:
1. Pour water into water tank, the water level should not exceed the "MAX" mark in
the tank. Then close the water tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning, you can fill
the tank with water firstly, and then put the tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh).
3. Place an espresso cup (your cup) on removable cup shelf. Make sure the coffee/
steam knob is on the .
4. Connect to power source, press down the ON/OFF button to the lower position
which is the ON position. The red indicator will be illuminated.
5. The appliance begins to be pre-heated until the green indicator is illuminated, it
shows the pre-heating is finished. Turning the coffee/steam knob to the
and water will flow out.
6. After about one minute, turn the coffee/steam knob to the  position to stop
brewing, you can pour the water in container out then clean them thoroughly, now
you can start brewing.
Note: There may be noise when pumping the water on the first time, it is normal, the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
Pre-Heating
To make a cup of good hot Espresso coffee, we recommend you preheating the
appliance before making coffee, including the funnel, steel mesh and cup, so that the
coffee flavour can not be influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water,
the water level should not exceed the "MAX" mark
the tank. Then place t he tank into the appliance
properly.
2. Set steel mesh into metal funnel, make sure the tube
on the funnel aligns with groove in the appliance,
then insert the funnel into the appliance from the
"Insert" position, and you can fix them into coffee
maker firmly through turn it anticlockwise until it is at the lock position.(See fig. 1)
3. Place an espresso cup (your cup) on removable cup shelf.
4. Then connect the appliance to power supply source. Make sure the coffee/steam
knob is on the  position.
5. Press the ON/OFF button to the lower position which is the ON position, the red
indicator will be illuminated.
6. When the green indicator is illuminated, you should turn the coffee/steam knob to
the . position, there will be hot water flowing out. After about one minute, close
the coffee/steam knob by turning the coffee/steam knob again to the  position.
position,
in
EN
19