Faq; Power Cuts; Safety; Recommendations - LODEL RA-600 Mode D'emploi

IMPORTANT: If you wish to modify the previously
assigned temperatures for each operating mode then
follow the steps given in section 5.5 of these
instructions.
EXAMPLE PROGRAMME:
• The programmed actual day. (1
Monday).
• The approximate room temperature (Example
21.6 ºC).
• The current time band flashes (17:00 – 18:00).
• The mode programmed in each time band:
Comfort Mode (sun).
• The heater element is switched on
Note: If this symbol is not shown, the heater is not
consuming power.
IMPORTANT:
Pressing the "PROG" button will change between
manual and automatic modes (programmed).
Note: After working for two or three months, the
clock will usually require adjustment.
6

FAQ

I. If the unit does not heat:
a. Verify that it is switched on.
b. Check that the power consumption indicator is on;
otherwise, increase the temperature assigned to
each mode.
II. If the unit does not provide sufficient heat:
a. Check whether the flame symbol is displayed and
if it appears intermittently, increase the
temperature assigned to each mode.
b. Check that the installed heater has adequate
7

Power cuts

If there is a power cut, the heater will not work, but
Fig. 24
will be switched on again in the same mode as before
when the power is re-established.
All previous adjustments will remain unaltered
(temperatures and programmes), "EXCEPT THE CLOCK
AND THE CURRENT DAY OF THE WEEK".
If, d uring a n a bsence f rom y our d welling, y ou d iscover t hat
the h eaters a re n ot w orking:
When the mains power has been restored, the clock and
current time must be reprogrammed.
power for the room size.
8

Safety

.
Do NOT cover the heater
•
clothes. If it is covered, there will be a serious risk
of overheating.
• The unit is fitted with a safety device that will
switch it off in case of overheating. It will
automatically switch on again when the problem is
resolved. If this problem repeats itself it could
cause damage or faults that are not covered by the
warranty.
9

Recommendations

• Remember that the economy mode should be used
when there is nobody in the room or at night. The
comfort mode provides the desired temperature when
the room is occupied.
• The anti-frost mode should not be used unless in
an extremely cold climate.
• Always remember to maintain intermediate
temperatures and extremely high or low values
should not be established.
. Do NOT use it to dry
9 33