LODEL RA-600 Mode D'emploi page 29

C
E
4. ASSEMBLY
4.1 While respecting the previously indicated safety
measurements, make two marks on the wall
according to measurement "e" indicated in Table 1
and at a height of 695 mm from the floor (not the
skirting board).
e
Skirting board
Fig. 5
4.2 Drill two 10-mm
minimum length of 60 mm at the
4.3 Screw the hooks (C) into the two holes, with
the two screws and two plugs (D).
Fig. 6
4.4 Screw the two brackets (A) (or one support,
depending on model) to the rear part of the heater
with the four screws (E) (or two screws, depending on
model).
Note: The two brackets (A) are screwed to the holes
located on the lower rear part, at both ends.
D
F
Feet
695
mm
diameter holes, with a
wall marks.
Fig. 7
4.5 Hang the heater on the two hooks (C) on the wall.
Ensure that the heater is correctly secured on both
hooks.
Hanger
Hook (C)
4.6 When the heater is fitted in place, make two marks
on the wall at the two brackets (A) to ensure the
heater is fixed to the wall:
4.7 Drill two 4-mm diameter holes, with a minimum
depth of 25 mm at the two marks on the wall.
4.8 Use the two screws and two plugs
completely secure the heater to the wall.
Fig. 8
Fig. 9
Fig. 10
B) to
Fig. 11
5
29